The following steps are required to install the transmission friction plate: Prepare required tools, such as wrench, wrench, support tool, spline hammer, and oil seal installation tool. Remove the vehicle's transmission and clutch. Use a box wrench to separate the transmission, and then clean the oil and debris in the transmission. Install the new clutch, taking care to align the spline, and gently tap the spline with the spline hammer to align the spline with the synchronizer. Place the clutch pressure plate and clutch housing in place and install the fastening bolts. Install the clutch retainer, then flatten the spring of the clutch pressure plate. The oil seal installation tool puts the oil seal back into the transmission, then installs the backstop and cleans the transmission again. Fastens transmission and engine connection bolts, connects drive shaft to transmission. Adjust and check the clutch system before the vehicle starts.
We use cookies to offer you a better browsing experience, analyze site traffic and personalize content. By using this site, you agree to our use of cookies.
Privacy Policy
